![]() Periodically certain actions of the ASME Y14 Committee may be published as Cases. Written interpretations of the requirements of this Standard issued to this edition. This Standard will be revised when the Society approves the issuance of a new edition. No reproduction or networking permitted without license from IHS Provided by IHS under license with ASME Licensee=FMC Technologies /5914950002 Approved for public release distribution is unlimited. ![]() Verify the currency of the information above using the ASSIST Online databaseĭISTRIBUTION STATEMENT A. Since organizations and responsibilities can change, you should NOTE: The activities listed above were interested in this document as of the date Copies of this document may be purchased from The American Society of MechanicalĮngineers (ASME), 22 Law Drive, P.O. Army Research, Development and Engineering Center (ARDEC), ATTN: AMSRD-AAR-QES-E, PicatinnyĪrsenal, NJ 07806-5000. ![]() Proposed changes by DoD activities must be submitted to the DoD Adopting Activity: Commander, ASME Y14.5, Dimensioning and Tolerancing, was adopted on 9 February 2009 for use by the Department ofĭefense (DoD).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |